Synthesis of aspirin data

Secondary headaches, meaning those Synthesis of aspirin data by another disorder or trauma, should be promptly treated by a medical provider.

Clean and dry any glassware used and return it to the appropriate location. The crystal product will be stuck at the top of the capillary tube. After the reaction was complete some unreacted acetic anhydride and salicylic acid was still be present in the solution as well as some sulfuric acid, aspirin, and acetic acid.

In solution with alkalis, the hydrolysis proceeds rapidly and the clear solutions formed may consist entirely of acetate and salicylate. The personal yield was nearly zero, likely due to side reactions. Salicylate is also produced as a result of exposure to bismuth subsalicylatemethyl salicylateand sodium salicylate.

In acute poisoning, a single large dose is taken; in chronic poisoning, higher than normal doses are taken over a period of time. To most directly measure rate, the concentration of a product should be measured periodically over time.

To most directly measure rate, the concentration of a product should be measured periodically over time. Acetylsalicylic acid, also known as aspirin, is one of the most widely used medications to reduce fever and is also used as a pain killer.

Synthesis of Aspirin Lab Report

The theoretical yield of 5. Load the capillary tube into the melting point apparatus and begin heating. Some test tubes developed into a gummy polymer of salicylic acid, likely because they were heated for too long.

Iron III chloride can be coordinated and then reduced by deprotonated phenol. The history of aspirin began in when Edward Stone wrote a paper to the Royal Society of London that claimed that willow bark could cure ague, which is now known as malaria.

Ethanol was used to dissolve aspirin along with the impurities such as salicylic acid and others. This is quite far from the theoretical yield because it still contains impurities. Small esters are actually fairly soluble in water but solubility falls with chain length and hydrophobic parts.

Allow the product to vacuum dry for 5 minutes.

Synthesis of Aspirin

The table above depicts the various masses and volumes of calculated and raw data in the synthesis of aspirin. grams of salicylic acid was used with mL of acetic anhydride. The calculated mass of acetic anhydride was calculated using it’s known density for a mass of grams.

The mass of aspirin and filter paper was grams. 1 Aspirin is the common name for the compound acetylsalicylic acid, widely used as a fever reducer and as a pain killer. Salicylic acid, whose name comes from Salix, the willow family of plants, was derived from willow bark extracts.

Synthesis of Aspirin Data

Synthesis of Aspirin By: Jon Torre Purpose: To determine which of four catalysts yields the fastest reaction rate in the acetylation of salicylic acid (1) to form acetylsalicylic acid (2). Reactions: Procedure and Results: Aspirin Synthesis Tap water was heated on a steam bath in a mL beaker.

Synthesis of Aspirin By: Jon Torre Purpose: To determine which of four catalysts yields the fastest reaction rate in the acetylation of salicylic acid (1) to form acetylsalicylic acid (2).

Reactions: Procedure and Results: Aspirin Synthesis Tap water was heated on a steam bath in a mL beaker. The Synthesis and Analysis of Aspirin Mariam El-Magbri Department of Chemistry, American University, Washington, D.C.

was massed to g and recorded in the data table. The mass of the dry aspirin sample was calculated and recorded in the data table (3). Synthesis of Aspirin Salicylic acid derivatives, or salicin, are found in the bark of the willow tree.

In the 5th century B.C., Hippocrates ground the bark into a powder, and later, the Natives Americans chewed on the bark to alleviate fever and pain1.

Synthesis of aspirin data
Rated 0/5 based on 48 review
Synthesis of Aspirin Data Essay – Free Papers and Essays Examples